Xem mẫu
- Froggy Went A Huntin’
The book mark
Copyright 1996 Perry Bailey
Note, I use foil paper in making
The Paper I used this model, you don’t have to, but it
was 1X4 for the fits better into the book that way. In
dimensions. fact the first one was made from a
foil wrapper from a Hershey bar.
1 PVB
Fold and crease
the paper length-
2
Fold a waterbomb
base at the top.
3
Valley fold the
sides into the
center, while
folding over 1
flap over the
other of the
water bomb
base.
4
Mountain fold the flap inside
of the model upwards so
that the open part of the 5
flap is on the top. Repeat
on the other side. Fold the top flap back
to the other side.
6
Squash fold the flap
as shown to the center. 7
Petal fold the flap up.
Repeat steps 6 and 7
on the other flap.
- 8 9
Reverse fold the Now you can either
points out on each fold the frogs legs
side to form the a little thick as I do
frogs legs. or if you prefer you
can thin them first.
11
10
Mountain fold the tip
Pull out (reverse fold) under to form head
the inner flaps to make to form sides, valley
the front feet. These fold the bottom layer
you may want to thin a and mountain fold
little. the upper layer. To
form the backside
of the frog mountain
fold all but the legs
underneath. This
should give you the
finished frog.
12 13
Almost finished frog. And now we begin
Flip the paper 180 degrees the fly! Fold down
to the other side. one layer to the
edge,
- 14
Fold the flap back up
after you use it to make
the fold shown 15
Use the edge as a
marker of where to
fold down. Make the
fold then unfold, and
re-fold at the second
fold down.
17
16
Fold the flap up to the
Reverse fold the sides top of the model.
inwards.
18
Pull down and squash
the points to make the
fly’s wings. 19
This is sort of a cross
between a swivel fold
and a spread squash.
You fold the wings out
while bringing down
the top flap and folding
it into a rectangle.
- 23 Now the final folds,
fold everything but
the frog and the fly
under as shown.
20
24
Fold the top layer underneath on
both sides, as if for a paper plane. Now it is finished
This will thin the body of the fly. our ambitious frog
ever in pursuit of
Lunch. Now go
smash ,em into
a book!
21
Now fold over the entire top
of the model, this gives your fly
a head.
22
Gently pull the wings apart and
then crease them into a good
looking position.
nguon tai.lieu . vn
