Xem mẫu
ENGLISH FOR AUTOMOBILE ENGINEERING
UNIT 4 MANUAL OPERATION
Lecturer: Lang Van Thang
Presentation
Select the correct instructions for the actions in Figure 4.1: For example: A = 2
1. Turn the jack handle anticlockwise to lower the car. 2. Turn the gear wheel anticlockwise to raise the drill. 3. Turn the bolt clockwise to tighten it.
4. Press the top button to stop the motor. 5. Press the largest pedal to stop the car.
6. Pull the handle down to cut the metal bar. 7. Push the bar down to raise the load
Practice 1
Use the diagrams below and words in the presentation to complete the instructions:
Practice 2
Read the instructions for checking a spark plug; then put
them in the correct order.
1. Remove the plug from the socket.
2. Place the spanner over the spark plug. 3. Replace the spark plug in the socket. 4. Insert the gauge in the gap.
5. Remove the cover.
6. Examine the gap and check that it is clean.
7. Rotate the plug anticlockwise until it is loose.
8. Check that the gap is between 0.65 and 1.00 mm wide. 9. Replace the cover.
10.Rotate the plug clockwise until it is hand-tight. 11.Place the spanner over the plug and give a quarter turn
clockwise.
12.Caution: do not over-tighten the plug.
...
- tailieumienphi.vn
nguon tai.lieu . vn