Xem mẫu

ME-430 INTRODUCTION TO COMPUTER AIDED DESIGN SHEET METAL CLIP Pro/ENGINEER Wildfire 2.0 Dr. Herli Surjanhata Create a sheet metal part called CLIP. Make sure you select Sheetmetal as Sub-type. You need to create a Flat Wall base feature with thickness of 0.011. Click the icon, or From Insert pull-down menu, select Sheetmetal Wall -> Unattached -> Flat Pick the FRONT datum plane as sketching plane, and TOP datum plane as top reference orientation. Sketch the following section, 1 Click the icon, and enter the thickness of the wall 0.011. Select the OK button. 2 Create a Bend feature using the Bend, Roll, w/Transition, Part Bend Tbl, and Inside Rad options. Click the Create Bend icon or, Insert -> Bend Operation -> Bend Roll -> w/Transition -> Done Part Bend Tbl -> Done/Return Inside Rad -> Done/Return Pick the front surface of the sheet metal as sketching plane. Okay -> Default Pick the top edge of sheet metal as additional reference. First, sketch the bend line as shown in the Figure. Sketch this straight vertical line as the bend line. Click this icon to continue. Create the feature to Both sides of the bend line. 3 Pick Both Choose Okay when prompted for area to remain fixed. Pick two vertical edges of the narrow section of the part as additional references. Close. 4 Sketch the transition area as shown Figure. Make sure the sketch the line closest to the bend area first. Click this icon to continue. Answer [N] when prompted if you want to define another transition area. FIRST Select Enter Value SECOND The radius will be 0.16. Click OK. Create an Unbend feature. Pick the icon, or Insert -> Bend Operation -> Unbend 5 ... - tailieumienphi.vn
nguon tai.lieu . vn