ME-430 INTRODUCTION TO COMPUTER AIDED DESIGNTORSIONAL ANALYSIS Using Pro/MECHANICA Pro/ENGINEER
ME-430 INTRODUCTION TO COMPUTER AIDED DESIGNTORSIONAL ANALYSIS Using Pro/MECHANICA Pro/ENGINEER
ME-430 INTRODUCTION TO COMPUTER AIDED DESIGN TORSIONAL ANALYSIS Using Pro/MECHANICA Pro/ENGINEER Wildfire 2.0 Dr. Herli Surjanhata The U-Joint shown in the figure below is made of steel. A torsion load of 10,000 INLB is uniformly applied over the top portion surface of the U-Joint. Determine the von Mises stresses, and maximum deflection under the given torsion load and boundary conditions. Check the convergence of your analysis. Step 1: Using Pro/ENGINEER, create a base feature as shown in the
